|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Replacing Belt for a GE washer |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
09-02-2008, 11:07 AM
|
|||
|
|||
Replacing Belt for a GE washer
Model Number: WDSS4120AWW Brand: GE Age: 1 - 5 years
Opened the front panel of the washer and took out the broken belt. Looking at the setup it seems easy to put the belt on the pully under the drum, however I was not sure how I can slip the belt on the pully that is between the motor and the pump. Do I have to dismantle the pump or the motor in order to gain free access to the smaller pully above the pump. The pump is made of plastic and I am not sure how strong it is; I am afraid I will break it if I try to pry it open somehow. Can anyone here help?
Thanks Related Models     
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
09-02-2008, 11:11 AM
|
||||
|
||||
|
Here is a diagram, go to section #4...Model WDSS4120A0WW
The pump should have 2 clips holding it to the motor, remove those, and pull the pump off the motor shaft, you will need some force, but it will come off.
__________________
|
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Replacing the belt on a whirlpool washer | Escargot58 | Dishwasher Repair | 0 | 09-25-2009 02:22 PM |
| Replacing GE Washer belt | Matthew65 | Washer Repair | 1 | 09-10-2009 08:08 AM |
| Replacing washer belt | frontline | Dishwasher Repair | 0 | 08-31-2009 10:51 AM |
| Replacing Washer Belt | Ritchie | Washer Repair | 3 | 08-24-2009 06:08 AM |
| help replacing a belt | parajay84 | Dryer Repair | 1 | 10-14-2008 04:16 PM |
Linear Mode
