Rank: Member
Groups: Registered
Joined: 8/7/2010(UTC) Posts: 3
|
The washer stopped in the middle of a cycle. No codes were flashed and the control panel would allow selections but no response from the washer. I inititailly checked the continuity in the grey ribbon cable and it checked out OK. I have also checked the continuity in the wiring hrnesses from the door lock switch to the ECU. I have replaced the ECU and the electronic control panel and no change. I am down to either the motor control unit or the door switch. ANy ideas out there?
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close