Washer Repair

gdbrr1 · #1 (**permalink**) 08-02-2010, 07:47 AM

How do you replace the water level switch on my Whirlpool Washer.

ThatGuy · #2 (**permalink**) 08-02-2010, 01:00 PM

Quote:

Originally Posted by gdbrr1

How do you replace the water level switch on my Whirlpool Washer.

Its not too bad of a job. There are two screws located at each end of the control panel on the back side. Loosen these until the control panel can be pulled forward about half an inch. Then the control panel just rotates up and back on it own hinges. Take the knob off the pressure switch and then disconnect the wires and pressure dome tube. There should be a tab you pull back and rotate the whole pressure switch until it is free of the control panel. Reverse to reassemble.

part no. AP3890868

gdbrr1 · #3 (**permalink**) 08-02-2010, 10:16 PM

Thank for your reply. I'll be tackeling this job when the switch comes in.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Lid Switch replacement	aoflaherty	Washer Repair	1	04-25-2009 03:26 PM
Replacement switch	CBull	Oven Repair (including Ranges and Cooktops)	3	12-25-2008 03:46 AM
lid switch replacement	MichelleLask	Washer Repair	2	10-29-2008 09:28 AM
Lid Switch replacement	cwat12	Washer Repair	4	10-21-2008 03:41 PM
Air Switch Replacement	Big Dog	Oven Repair (including Ranges and Cooktops)	0	06-03-2008 07:25 AM

switch replacement

Washer Repair

How do you replace the water level switch on my Whirlpool Washer. Ads By Google Related Models Whirlpool&nbsp; WTW5320SQ0 &nbsp;Automatic

How do you replace the water level switch on my Whirlpool Washer. Ads By Google Related Models Whirlpool WTW5320SQ0 Automatic