Washer Repair

SRB · #1 (**permalink**) 07-31-2008, 08:40 PM

My Fisher & Paykel washer model #GWL10US purchased in 2001 is not working. It will not fill or spin. It tries for a couple of seconds and repeats several times, then beeps every second with the lighting code as follows: _ _ G _ G _ Y R
I made sure the inlet screens on both cold and hot were clean. I also confirmed that the discharge hose was clear and inspected the diverter valve for debris. Please help, the clothes are piling up.

dadoes · #2 (**permalink**) 11-02-2008, 11:34 AM

Fault code 43 refers to the out-of-balance switch. It's either stuck on, corroded/gone bad, or (less likely) the motor control board is bad.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
display comes on but washer will not work	Juanita Tedder	Washer Repair	0	07-08-2008 01:56 PM
washer wont work	ckrush	Washer Repair	1	01-20-2008 10:56 AM
My Maytag washer does work	yzhong	Washer Repair	1	11-01-2007 04:10 PM
My Maytag washer does work	yzhong	Dryer Repair	0	10-31-2007 02:48 PM
Washer does not work, Humming noise	mickey11	Washer Repair	0	09-27-2007 07:32 PM

washer will not work

Washer Repair

My Fisher & Paykel washer model #GWL10US purchased in 2001 is not working. It will not fill or spin. It