Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > Search Forums » Search Results

Showing results 1 to 25 of 500
Search took 0.07 seconds.
Search: Posts Made By: abadfish66
Forum: Microwave Repair 12-30-2017, 07:53 PM
Replies: 1
Views: 954
Posted By abadfish66
That loud buzzing noise could just be a bad...

That loud buzzing noise could just be a bad diode, but in all my years experiance, it most likely is a bad magnetron. When replacing the magnetron, you will want to change the diode as well, because...
Forum: Oven Repair (including Ranges and Cooktops) 12-30-2017, 07:42 PM
Replies: 1
Views: 572
Posted By abadfish66
I'm assuming this is a glass top range with the...

I'm assuming this is a glass top range with the burner under the glass. Cycling of the element is normal, meaning glowing red for a few seconds and shutting off and continuing that cycle. Is this...
Forum: Oven Repair (including Ranges and Cooktops) 12-30-2017, 07:36 PM
Replies: 1
Views: 610
Posted By abadfish66
You bake glow bar is most likely bad. Here is the...

You bake glow bar is most likely bad. Here is the part# needed AP3202322 you can check the amp draw on one of the wires should be between 3.2-3.8 amps. glow bars generally only last about 5-6 years...
Forum: Refrigerator & Freezer Repair 08-03-2017, 11:38 PM
Replies: 3
Views: 450
Posted By abadfish66
From what you wrote about the fridge, I dont...

From what you wrote about the fridge, I dont think anything is wrong with it. You mention the temps are -2 and 33? Those are pretty good temps, you probably have the temp in the fresh food turned to...
Forum: Refrigerator & Freezer Repair 08-30-2016, 04:47 PM
Replies: 1
Views: 1,281
Posted By abadfish66
They come pre filled.

They come pre filled.
Forum: Oven Repair (including Ranges and Cooktops) 08-27-2016, 11:36 PM
Replies: 2
Views: 425
Posted By abadfish66
Sounds like you have a bad bake glow bar. If you...

Sounds like you have a bad bake glow bar. If you can get amperage reading on the bake glow bar while its glowing it should read 3.2-3.6 amps. if it reads 3.2 and below, it's a bad glow bar.
Forum: Washer Repair 08-19-2016, 06:17 PM
Replies: 5
Views: 2,757
Posted By abadfish66
This model actually does not have a fuse. Check...

This model actually does not have a fuse. Check the lid switch for a torn wire. Open the front and locate, should have an orange and yellow wire if im not mistaken.
Forum: Microwave Repair 08-19-2016, 06:10 PM
Replies: 2
Views: 2,050
Posted By abadfish66
Sounds like one of the door switches is bad....

Sounds like one of the door switches is bad. Part# AP2024367
Forum: Refrigerator & Freezer Repair 08-19-2016, 06:03 PM
Replies: 1
Views: 446
Posted By abadfish66
Check the inside back wall of the freezer. Is it...

Check the inside back wall of the freezer. Is it covered with heavy frost? Is the freezer fan running? Also check if the compressor is running. May be able to help when you check those .
Forum: Refrigerator & Freezer Repair 02-26-2013, 12:03 AM
Replies: 1
Views: 1,699
Posted By abadfish66
Check windings of compressor, com-start, com-run...

Check windings of compressor, com-start, com-run and run-start windings should all be the same ohms, if not, the compressor is bad and frying the invertor.
Forum: Refrigerator & Freezer Repair 12-07-2012, 10:13 PM
Replies: 2
Views: 1,848
Posted By abadfish66
Your control board needs to be replaced. Here is...

Your control board needs to be replaced. Here is your part # WR55X10942
Forum: Refrigerator & Freezer Repair 12-06-2012, 11:51 PM
Replies: 4
Views: 1,993
Posted By abadfish66
This is the part you need for the refer temps too...

This is the part you need for the refer temps too cold AP3775595 The damper door is broken and allowing cold air into the refer section and not being able to regulate how much air...As far as...
Forum: Refrigerator & Freezer Repair 12-05-2012, 11:11 PM
Replies: 4
Views: 1,890
Posted By abadfish66
There are no generic ones you can use for this...

There are no generic ones you can use for this fridge. I also recommend you replace the defrost thermostat as that may have been the reason it froze up on ya...WR50X122
Forum: Refrigerator & Freezer Repair 12-03-2012, 11:28 PM
Replies: 3
Views: 2,640
Posted By abadfish66
That tube is actually the defrost water drain...

That tube is actually the defrost water drain tube. As the evaporator heater comes on it melts the frost off the coils, that water runs down that tube and into a tray to evaporate away. You may have...
Forum: Refrigerator & Freezer Repair 12-03-2012, 12:56 AM
Replies: 2
Views: 2,414
Posted By abadfish66
That connector supplies power to you blank board...

That connector supplies power to you blank board and water/ice dispenser
Forum: Oven Repair (including Ranges and Cooktops) 11-30-2012, 11:35 PM
Replies: 5
Views: 1,949
Posted By abadfish66
I am strictly going off memory here, but I do...

I am strictly going off memory here, but I do know the ground wire is not needed, tape the end off the ground wire and forget about it. next the Purple broil wire goes to the black broil relay. If...
Forum: Refrigerator & Freezer Repair 02-08-2012, 10:35 PM
Replies: 8
Views: 3,463
Posted By abadfish66
Applianceman, Do you work for GE?

Applianceman, Do you work for GE?
Forum: Refrigerator & Freezer Repair 02-08-2012, 10:34 PM
Replies: 8
Views: 3,463
Posted By abadfish66
Well said applianceman, I missed that...

Well said applianceman, I missed that one...forgot about the door sagging issue...Usually the customer will say the fridge is hot, not room temp, that is why I assumed the board and not the sagging...
Forum: Refrigerator & Freezer Repair 02-08-2012, 08:07 PM
Replies: 8
Views: 3,463
Posted By abadfish66
your on the right track...8 years as a GE repair...

your on the right track...8 years as a GE repair guy....
Forum: Refrigerator & Freezer Repair 02-08-2012, 07:42 PM
Replies: 2
Views: 1,155
Posted By abadfish66
if you hear a hum, then a click, most likely your...

if you hear a hum, then a click, most likely your problem is a bad compressor start device. AP3884299 (http://www.appliancepartspros.com/Appliance-Parts/ge-5sp-overload-ptc-item-number-ap3884299.aspx)
Forum: Washer Repair 02-08-2012, 06:20 PM
Replies: 1
Views: 3,138
Posted By abadfish66
Done it many times, some come out easy and others...

Done it many times, some come out easy and others need some good conversation and a drink...I have never needed a tool to remove the basket from the outer tub..normally I will lay it on the back...
Forum: Oven Repair (including Ranges and Cooktops) 02-07-2012, 09:26 PM
Replies: 1
Views: 2,317
Posted By abadfish66
I would guess the repair being faulty. The relay...

I would guess the repair being faulty. The relay that controls the heat is stuck in the on position instead of cycling on and off.
Forum: Dryer Repair 02-07-2012, 09:22 PM
Replies: 5
Views: 4,098
Posted By abadfish66
yes. both coils should be replaced

yes. both coils should be replaced
Forum: Dryer Repair 02-07-2012, 08:01 PM
Replies: 5
Views: 4,098
Posted By abadfish66
Sounds like the gas coils have gone bad...diagram...

Sounds like the gas coils have gone bad...diagram #7 on your model, items 729 and 731 are the coils you need...
Forum: Dishwasher Repair 02-07-2012, 07:54 PM
Replies: 4
Views: 3,358
Posted By abadfish66
make sure the water is turned on, sounds silly,...

make sure the water is turned on, sounds silly, but it happens.
Showing results 1 to 25 of 500

 
Forum Jump


All times are GMT -7. The time now is 05:32 AM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17