Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > Search Forums » Search Results

Showing results 1 to 25 of 500
Search took 0.32 seconds.
Search: Posts Made By: fairbank56
Forum: Washer Repair Today, 10:25 AM
Replies: 25
Views: 11,184
Posted By fairbank56
Need to find the pressure switch. Trace the...

Need to find the pressure switch. Trace the white/red wires from the load size switch. They go to the
pressure switch. Need to see photo's of pressure switch. This is a new arrangement that...
Forum: Washer Repair Today, 05:43 AM
Replies: 25
Views: 11,184
Posted By fairbank56
Almost, but not quite there yet. I have to be...

Almost, but not quite there yet. I have to be able to read the numbers, wire colors, letters...hard to read on the second main wiring diagram. Also, will need to be able to read the timer chart when...
Forum: Washer Repair Yesterday, 06:56 AM
Replies: 1
Views: 104
Posted By fairbank56
This could be caused by a faulty water level...

This could be caused by a faulty water level pressure switch, speed switch or timer. To rule out the pressure switch, place timer at one click before drain begins. This is the last 2 minutes of...
Forum: Washer Repair 09-28-2014, 04:23 PM
Replies: 25
Views: 11,184
Posted By fairbank56
Need to upload much higher resolution images, I...

Need to upload much higher resolution images, I cannot possibly interpret the wiring from those tiny images.

Eric
Forum: Dryer Repair 09-28-2014, 05:55 AM
Replies: 2
Views: 198
Posted By fairbank56
The gas burner is supposed to come on/off during...

The gas burner is supposed to come on/off during a normal cycle. That's what the thermostat that you jumped out is for. With it jumped out, it will just stay on and overheat. Cycling the burner...
Forum: Washer Repair 09-27-2014, 11:38 AM
Replies: 25
Views: 11,184
Posted By fairbank56
Wiring diagram is usually inside the control...

Wiring diagram is usually inside the control panel or pasted onto the inside of the back panel. That is a 3 position switch, not a solenoid. I see a relay next to the switch but not sure what it's...
Forum: Washer Repair 09-27-2014, 10:49 AM
Replies: 25
Views: 11,184
Posted By fairbank56
Might be able to help if you can provide a...

Might be able to help if you can provide a copy/photo of the wiring diagram.

Eric
Forum: Washer Repair 09-26-2014, 06:45 AM
Replies: 1
Views: 114
Posted By fairbank56
Remove the wash plate and check for stripped...

Remove the wash plate and check for stripped splines on the drive block and transmission spin tube (outer shaft).

Eric
Forum: Washer Repair 09-25-2014, 02:22 PM
Replies: 2
Views: 128
Posted By fairbank56
Whirlpool W10349191 Suspension -...

Whirlpool W10349191 Suspension - AppliancePartsPros.com (http://www.appliancepartspros.com/whirlpool-suspension-w10349191-ap4695818.html)
Forum: Washer Repair 09-25-2014, 11:19 AM
Replies: 22
Views: 1,135
Posted By fairbank56
The pulley hub, pulley and pulley nut holds...

The pulley hub, pulley and pulley nut holds everything together.

Eric
Forum: Washer Repair 09-25-2014, 06:13 AM
Replies: 3
Views: 136
Posted By fairbank56
Well, you shouldn't let it sit just buzzing as it...

Well, you shouldn't let it sit just buzzing as it can damage the start capacitor and the motor. I think there may be a faulty timer contact or possibly loose connections at the capacitor. Unplug the...
Forum: Washer Repair 09-24-2014, 06:46 PM
Replies: 10
Views: 250
Posted By fairbank56
If you apply power directly to the motor, you...

If you apply power directly to the motor, you must apply it to the start winding with capacitor in line as well as to one of the run windings.

Eric
Forum: Dryer Repair 09-24-2014, 12:44 PM
Replies: 1
Views: 148
Posted By fairbank56
Double check that model number, doesn't come...

Double check that model number, doesn't come up.

Eric
Forum: Washer Repair 09-24-2014, 12:37 PM
Replies: 3
Views: 136
Posted By fairbank56
Check for loose screws on the left side lid...

Check for loose screws on the left side lid hinge. That hinge activates the lid switch and it's relatively common for the screws to loosen.

Eric
Forum: Washer Repair 09-24-2014, 12:32 PM
Replies: 3
Views: 150
Posted By fairbank56
Well, that doesn't really help me narrow down the...

Well, that doesn't really help me narrow down the problem. The way to figure this out is to do some electrical troubleshooting with multimeter and wiring diagram in hand. If you have no experience in...
Forum: Washer Repair 09-23-2014, 06:15 PM
Replies: 10
Views: 250
Posted By fairbank56
There should be a start capacitor. It's generally...

There should be a start capacitor. It's generally mounted to the motor or the inside of the back panel of the washer. When you get power to the washer, set it to spin and if motor just hums, with...
Forum: Dryer Repair 09-23-2014, 04:06 PM
Replies: 1
Views: 177
Posted By fairbank56
No, the thermostats do not control the motor....

No, the thermostats do not control the motor. Check the door switch and the belt (idler) switch.

Eric
Forum: Washer Repair 09-23-2014, 03:49 PM
Replies: 3
Views: 150
Posted By fairbank56
There is a thermal overload switch in the motor...

There is a thermal overload switch in the motor but that would not prevent the washer from filling if it was tripped. After you do a load and then washer will not fill when trying another load, will...
Forum: Washer Repair 09-23-2014, 02:56 PM
Replies: 6
Views: 298
Posted By fairbank56
You need to determine exactly where the oil is...

You need to determine exactly where the oil is leaking from. Just because it's dripping off the bottom most part of the transmission, doesn't mean that's where the leak is. It could very well be the...
Forum: Washer Repair 09-23-2014, 02:46 PM
Replies: 3
Views: 156
Posted By fairbank56
With transition panel removed, check for a couple...

With transition panel removed, check for a couple screws to remove to allow you to pull washer top panel forward for removal. Not too sure on this model. No service manual available.

Eric
Forum: Washer Repair 09-23-2014, 02:01 PM
Replies: 10
Views: 250
Posted By fairbank56
You would have to pull the hoses off the pump to...

You would have to pull the hoses off the pump to get any more water out. The only part of the machine that runs off 240vac is the dryer heat element. You could disconnect the power cord from the...
Forum: Washer Repair 09-23-2014, 10:11 AM
Replies: 10
Views: 250
Posted By fairbank56
May be something in the drain pump jamming the...

May be something in the drain pump jamming the motor. Pump is attached to one end of the motor shaft. Open the front panel, unclip the pump and pull it off the motor shaft and see if it will now go...
Forum: Washer Repair 09-23-2014, 09:51 AM
Replies: 1
Views: 129
Posted By fairbank56
Probably a faulty lid switch. Whirlpool 3949247...

Probably a faulty lid switch.

Whirlpool 3949247 Lid Switch Assembly - AppliancePartsPros.com (http://www.appliancepartspros.com/whirlpool-lid-switch-assembly-3949247-ap3100003.html)

Eric
Forum: Washer Repair 09-23-2014, 06:33 AM
Replies: 3
Views: 156
Posted By fairbank56
Removing the angled panel between the dryer and...

Removing the angled panel between the dryer and washer should give you access to the lid switch.

Eric
Forum: Dryer Repair 09-21-2014, 03:09 PM
Replies: 4
Views: 155
Posted By fairbank56
Looks like I may be using the wrong wiring...

Looks like I may be using the wrong wiring diagram. According to the GE parts list, the tech sheet for your model is number 31-15415 however, the parts manual shows your dryer as having a control...
Showing results 1 to 25 of 500

 
Forum Jump


All times are GMT -7. The time now is 02:34 PM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17