Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > Search Forums » Search Results

Showing results 1 to 25 of 500
Search took 0.09 seconds.
Search: Posts Made By: Joe / APP Team
Forum: Washer Repair 12-18-2014, 07:34 AM
Replies: 44
Views: 25,096
Posted By Joe / APP Team
Mguerrero, Both error codes indicate an issue...

Mguerrero, Both error codes indicate an issue with the actuator. Since you've replaced it you'll want to check the J2 harness between the main control board and the motor/shifter. Make sure there are...
Forum: Washer Repair 12-17-2014, 12:42 PM
Replies: 44
Views: 25,096
Posted By Joe / APP Team
Burchis, Sometimes that's the best thing to do....

Burchis, Sometimes that's the best thing to do.

Good Luck, and thanks for the opportunity.
Forum: Washer Repair 12-15-2014, 07:53 AM
Replies: 44
Views: 25,096
Posted By Joe / APP Team
Burchis, Yes the lid has to be locked in the test...

Burchis, Yes the lid has to be locked in the test mode to operate the motor. So you'll need to re run the tests with the lid locked.
Also remember, the sensor in the actuator has to send the correct...
Forum: Washer Repair 12-12-2014, 07:44 AM
Replies: 44
Views: 25,096
Posted By Joe / APP Team
Burchis, Yes you should be using the manual test...

Burchis, Yes you should be using the manual test mode, and you should be able to press and release the start button. There is a five minute time limit on the test segments, but it shouldn't take you...
Forum: Washer Repair 12-10-2014, 09:05 AM
Replies: 44
Views: 25,096
Posted By Joe / APP Team
Burchis, To the best of our knowledge, no, no one...

Burchis, To the best of our knowledge, no, no one has attempted to run a motor on a test cord for this style washer, as of yet. It doesn't look that difficult, or involved, but without the necessary...
Forum: Washer Repair 12-05-2014, 03:50 PM
Replies: 44
Views: 25,096
Posted By Joe / APP Team
Burchis, We're pretty sure (99.9%) you're going...

Burchis, We're pretty sure (99.9%) you're going to need the shift actuator assembly
AP4514409
Just based on your description of the issue and the error code. If you wish to troubleshoot it further,...
Forum: Refrigerator & Freezer Repair 12-02-2014, 01:24 PM
Replies: 12
Views: 7,044
Posted By Joe / APP Team
Mrmagic, remove power to the refrigerator, and...

Mrmagic, remove power to the refrigerator, and remove the overload and start relay(leave the wires connected if possible.
the upper most pin on the compressor is the "common" leg.
From "C" to "S"...
Forum: Refrigerator & Freezer Repair 12-02-2014, 12:58 PM
Replies: 12
Views: 7,044
Posted By Joe / APP Team
Mrmagic, The clicking would usually indicate a...

Mrmagic, The clicking would usually indicate a weak or faulty start relay. You'd also want to test the compressor motor windings to make sure they haven't weakened or shorted to ground.

Of course...
Forum: Dryer Repair 10-29-2014, 07:08 AM
Replies: 16
Views: 14,584
Posted By Joe / APP Team
Gpeever, Good Luck !!! Let us know what happens.

Gpeever, Good Luck !!! Let us know what happens.
Forum: Dryer Repair 10-24-2014, 03:48 PM
Replies: 16
Views: 14,584
Posted By Joe / APP Team
Smile Gpeever, Since you've cleaned out the lint and...

Gpeever, Since you've cleaned out the lint and checked the exhaust vent and hood. You'll want to check the blower wheel and make sure it is a tight fit on the motor shaft. A loose or rounded blower...
Forum: Refrigerator & Freezer Repair 10-08-2014, 08:48 AM
Replies: 9
Views: 1,113
Posted By Joe / APP Team
Daydreamer, The part you're going to need is...

Daydreamer, The part you're going to need is

ACJ36695101

If it were available, it would be a complete assembly ( hinges and support arms, etc.) When you start to research use the ACJ number for...
Forum: Refrigerator & Freezer Repair 10-06-2014, 01:09 PM
Replies: 9
Views: 1,113
Posted By Joe / APP Team
Daydreamer, It's pretty tough researching parts...

Daydreamer, It's pretty tough researching parts without a complete model or part number. Once you have researched the parts screen and have a part number, you may need to review Obsolete or antique...
Forum: Washer Repair 09-22-2014, 10:43 AM
Replies: 11
Views: 14,968
Posted By Joe / APP Team
Adrian, The water level switch and air tube has...

Adrian, The water level switch and air tube has been used for many many years(at least 40 years that I know of) It's a lot better alternative than the previous timed filled systems. It's common to...
Forum: Washer Repair 09-22-2014, 08:20 AM
Replies: 11
Views: 14,968
Posted By Joe / APP Team
Adrian, Check and make sure there are no loose...

Adrian, Check and make sure there are no loose wires or connections at the CCU or water level switch. Under normal situations, everything you've done is correct, and should have solved the issue....
Forum: Washer Repair 09-16-2014, 09:42 AM
Replies: 7
Views: 922
Posted By Joe / APP Team
Carneyidaho, OK Good Deal...

Carneyidaho, OK Good Deal...
Forum: Washer Repair 09-16-2014, 08:07 AM
Replies: 7
Views: 922
Posted By Joe / APP Team
Carneyidaho, You can also add 1 cup of chlorine...

Carneyidaho, You can also add 1 cup of chlorine bleach to the tub, and fill the bleach dispenser then start the cycle. Make sure you select a hot wash cold rinse cycle. The bleach will help eliminate...
Forum: Washer Repair 08-20-2014, 07:41 AM
Replies: 21
Views: 6,227
Posted By Joe / APP Team
Bubver, We know the thermistor checks OK, so the...

Bubver, We know the thermistor checks OK, so the next move is to remove the TH2 connector from the CCU, and check for 9 to 10 ohms resistance across the two wires in the connector. If you have the...
Forum: Oven Repair (including Ranges and Cooktops) 08-18-2014, 09:43 AM
Replies: 6
Views: 3,609
Posted By Joe / APP Team
jejocrane, Thank you for the model number of your...

jejocrane, Thank you for the model number of your range. Your range is slightly different than the previous posts(they forgot to attach a model number).

In your case, you have to remove the complete...
Forum: Dishwasher Repair 08-18-2014, 09:01 AM
Replies: 40
Views: 40,804
Posted By Joe / APP Team
DPForumDog, Your first check should be to make...

DPForumDog, Your first check should be to make sure the water temperature in the bottom of the tub is at least 120 dgrs.F. on the first fill of the cycle. You're correct, there is cold water left in...
Forum: Washer Repair 07-15-2014, 12:49 PM
Replies: 8
Views: 5,436
Posted By Joe / APP Team
Thorning, The best place to get your parts is...

Thorning,
The best place to get your parts is right here at AppliancePartspros.com. All parts purchased have a 365 day "no hassle" return policy, and they have a one year parts warranty as well.
In...
Forum: Washer Repair 07-14-2014, 08:59 AM
Replies: 8
Views: 5,436
Posted By Joe / APP Team
Thorning, No, you won't have to remove the outer...

Thorning, No, you won't have to remove the outer tub assembly, But you will need to remove the front of the washer, shroud, boot, tub cover and spin basket and shaft.

Presumably you mean this unit...
Forum: Washer Repair 05-28-2014, 01:12 PM
Replies: 30
Views: 25,118
Posted By Joe / APP Team
Nicholas, You may want to check the wires to the...

Nicholas, You may want to check the wires to the RPS switch and make sure they didn't get dislodged or knocked loose in the move. But that's the least of your worries. You'll have to do something...
Forum: Oven Repair (including Ranges and Cooktops) 05-12-2014, 07:04 AM
Replies: 11
Views: 4,657
Posted By Joe / APP Team
Dkraines, Great Job... Thanks for the update,...

Dkraines, Great Job... Thanks for the update, we're glad all went well for you.
Forum: Refrigerator & Freezer Repair 04-28-2014, 03:00 PM
Replies: 7
Views: 2,767
Posted By Joe / APP Team
Jesusman, Open the freezer drawer and remove the...

Jesusman, Open the freezer drawer and remove the baskets and check the back wall of the freezer compartment for a heavy frost or ice build up on the back wall, this will indicate a defrost problem,...
Forum: Dishwasher Repair 04-28-2014, 12:55 PM
Replies: 40
Views: 40,804
Posted By Joe / APP Team
Silkfur, You may not need a repairman. The...

Silkfur, You may not need a repairman. The previous post recommended you check voltage to the valve or replace the fill valve. When the repairman get's the dishwasher up and going, let us know what...
Showing results 1 to 25 of 500

 
Forum Jump


All times are GMT -7. The time now is 04:49 AM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17