Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > Search Forums » Search Results

Showing results 1 to 25 of 500
Search took 1.42 seconds.
Search: Posts Made By: fairbank56
Forum: Dryer Repair Today, 10:34 AM
Replies: 1
Views: 69
Posted By fairbank56
We need a model number??? Eric

We need a model number???

Eric
Forum: Dryer Repair Today, 10:31 AM
Replies: 27
Views: 328
Posted By fairbank56
Ahhh, those things! Thought they quit selling...

Ahhh, those things! Thought they quit selling them a long time ago. Piece of junk, haven't seen one in a while. Oh well, easy fix after all that.

Eric
Forum: Dryer Repair Today, 08:51 AM
Replies: 27
Views: 328
Posted By fairbank56
I would check the voltage at the start switch...

I would check the voltage at the start switch with dryer motor running. One meter probe at a good ground or at timer T terminal and use other probe to check voltage at each blue wire. If one reads...
Forum: Dryer Repair Today, 08:08 AM
Replies: 27
Views: 328
Posted By fairbank56
Yes, it has a coil in it that keeps the switch...

Yes, it has a coil in it that keeps the switch closed once you manually close it. It should remain closed until power is removed from it via timer contacts or the door is opened. However, you said...
Forum: Dryer Repair Today, 07:41 AM
Replies: 27
Views: 328
Posted By fairbank56
Can't say. Not making any sense. You say timer is...

Can't say. Not making any sense. You say timer is advancing in wrinkle guard which means there is 120vac at timer BU terminal which also provides 120vac to start switch which provides 120vac to...
Forum: Dryer Repair Today, 06:44 AM
Replies: 27
Views: 328
Posted By fairbank56
Yes to both. As for the buzzer test, it tells me...

Yes to both. As for the buzzer test, it tells me that the motor switch is ok and again points to a timer problem. If your at all familiar with reading the wiring diagram, I can try to explain how...
Forum: Dryer Repair Today, 06:29 AM
Replies: 27
Views: 328
Posted By fairbank56
While timer is advancing in wrinkle guard, press...

While timer is advancing in wrinkle guard, press the start button. Start relay should engage and stay engaged. Motor should start within 5 minutes. If not, it sure sounds like a bad timer. You should...
Forum: Dryer Repair Yesterday, 06:36 PM
Replies: 27
Views: 328
Posted By fairbank56
Unplug the black wire from the start switch....

Unplug the black wire from the start switch. Stick a piece of wire into the quick disconnect terminal. Start the dryer. Holding only the insulated portion of the black wire, touch the wire to one of...
Forum: Dryer Repair Yesterday, 05:09 PM
Replies: 27
Views: 328
Posted By fairbank56
There should be either a tan or black wire from...

There should be either a tan or black wire from the buzzer to the start switch. Disconnect that wire from start switch and check continuity between that terminal on switch and the terminal that the...
Forum: Dryer Repair Yesterday, 03:19 PM
Replies: 27
Views: 328
Posted By fairbank56
Faulty motor switch would not cause both...

Faulty motor switch would not cause both problems. Check continuity on the wrinkle guard switch and the start switch buzzer control contacts.

Eric
Forum: Dryer Repair Yesterday, 03:02 PM
Replies: 27
Views: 328
Posted By fairbank56
The only function of the control board is to...

The only function of the control board is to advance the timer during auto dry cycle based on feedback from the moisture sensor bars. I assume you do have the buzzer switch turned on? It's part of...
Forum: Dryer Repair Yesterday, 02:08 PM
Replies: 2
Views: 138
Posted By fairbank56
Does this problem occur in manual timed dry cycle...

Does this problem occur in manual timed dry cycle as well? If only in auto cycles, suspect problem with moisture sensing bars. Dryer must have wet clothes in drum and functioning sensing bars in...
Forum: Dryer Repair Yesterday, 06:16 AM
Replies: 2
Views: 111
Posted By fairbank56
Faulty timer. Whirlpool 33002676 Timer,...

Faulty timer.

Whirlpool 33002676 Timer, Electronic Dry - AppliancePartsPros.com (http://www.appliancepartspros.com/whirlpool-timer-electronic-dry-33002676-ap4042871.html)

Eric
Forum: Washer Repair 07-22-2014, 04:04 PM
Replies: 11
Views: 463
Posted By fairbank56
Sounds like you forgot to install the washer...

Sounds like you forgot to install the washer and/or retaining clip on top of the spin gear. With those installed, there is no way the main drive gear can lift up from the worm gear.

Eric
Forum: Washer Repair 07-22-2014, 05:34 AM
Replies: 3
Views: 168
Posted By fairbank56
It's not the lid switch. On this model, if the...

It's not the lid switch. On this model, if the lid switch is bad, it won't agitate, drain or spin. Monitor the washer at end of agitation cycle. After agitation stops, the washer should drain for 2...
Forum: Washer Repair 07-21-2014, 08:25 AM
Replies: 1
Views: 118
Posted By fairbank56
Post video to youtube with front cover removed so...

Post video to youtube with front cover removed so we can hear it. Most likely the lower transmission bearing or tub bearing. Nothing "easy" about either. Possibly something between the tubs. Run...
Forum: Washer Repair 07-21-2014, 08:21 AM
Replies: 11
Views: 463
Posted By fairbank56
Don't put anything down inside the drive block....

Don't put anything down inside the drive block. The idea is to tap on the top surface of the drive block, away from the tabs on the drive tube, while lifting on the tub. The tub has become stuck to...
Forum: Washer Repair 07-20-2014, 04:55 PM
Replies: 3
Views: 175
Posted By fairbank56
You need to pull the transmission and then grab...

You need to pull the transmission and then grab and rotate the brake cam driver CCW. This should release the brakes and cause the basket to rotate. If that works ok, then the basket drive is ok. If...
Forum: Dryer Repair 07-20-2014, 06:23 AM
Replies: 27
Views: 328
Posted By fairbank56
No, timer should continue to run when door is...

No, timer should continue to run when door is closed regardless if drive motor is running or not. If ordered from APP, timer may be returned if it does not fix the problem.

Eric
Forum: Dryer Repair 07-19-2014, 04:08 PM
Replies: 27
Views: 328
Posted By fairbank56
Yes, sounds like a faulty timer. Whirlpool...

Yes, sounds like a faulty timer.

Whirlpool 8566184 Timer - AppliancePartsPros.com (http://www.appliancepartspros.com/whirlpool-timer-8566184-ap3859587.html)

Eric
Forum: Washer Repair 07-19-2014, 03:41 PM
Replies: 6
Views: 210
Posted By fairbank56
As I said, this is normal operation. It is done...

As I said, this is normal operation. It is done that way to save water. Of course, your not saving any water if you have to run another rinse cycle to get the soap out. Nothing you can do about...
Forum: Washer Repair 07-19-2014, 03:31 PM
Replies: 3
Views: 175
Posted By fairbank56
What is the clutch hub doing during spin? It...

What is the clutch hub doing during spin? It should be rotating. If it is, look up into the brake hub and see if the basket drive is also rotating. You should see the large brake spring going around....
Forum: Washer Repair 07-19-2014, 03:15 PM
Replies: 6
Views: 210
Posted By fairbank56
Yes, this is normal operation on this washer. It...

Yes, this is normal operation on this washer. It uses a separate water level pressure switch for rinse. The one for wash is user adjustable via the knob, the other for rinse is not. This is to comply...
Forum: Washer Repair 07-19-2014, 11:05 AM
Replies: 3
Views: 176
Posted By fairbank56
Sounds like a faulty timer. GE WH12X10254 Timer...

Sounds like a faulty timer.

GE WH12X10254 Timer - AppliancePartsPros.com (http://www.appliancepartspros.com/ge-timer-wh12x10254-ap3419314.html)

To rule out a pressure switch problem, open the...
Forum: Washer Repair 07-19-2014, 09:47 AM
Replies: 6
Views: 210
Posted By fairbank56
What is the washer model number? Eric

What is the washer model number?

Eric
Showing results 1 to 25 of 500

 
Forum Jump


All times are GMT -7. The time now is 11:26 AM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17