Register | FAQ's | New Posts | Today's Posts | Extras
Appliance Repair Forum > Search Forums » Search Results

Showing results 1 to 25 of 500
Search took 1.71 seconds.
Search: Posts Made By: Joe / APP Team
Forum: Oven Repair (including Ranges and Cooktops) Yesterday, 03:49 PM
Replies: 1
Views: 20
Posted By Joe / APP Team
Calbear, Yes it could be normal for the...

Calbear, Yes it could be normal for the "entire" stove to get very warm / hot when the oven is on. Especially the control panel and cooktop center. This is where the oven exhaust and vent is routed....
Forum: Oven Repair (including Ranges and Cooktops) Yesterday, 03:36 PM
Replies: 1
Views: 14
Posted By Joe / APP Team
JDC65, If the top burners work properly, you'll...

JDC65, If the top burners work properly, you'll want to check for a dirty or clogged bake burner, check and clean all the venturi openings on the burner. Then you want to suspect the DSI spark module...
Forum: Refrigerator & Freezer Repair Yesterday, 03:22 PM
Replies: 1
Views: 20
Posted By Joe / APP Team
Tim, With that much water on the floor(there's...

Tim, With that much water on the floor(there's also a defrost drain pan) you most likely have a defrost issue. you'll need to remove the back wall cover and test the heater element for a closed...
Forum: Refrigerator & Freezer Repair Yesterday, 02:17 PM
Replies: 2
Views: 26
Posted By Joe / APP Team
Smnorrick, for the warm refrigerator compartment,...

Smnorrick, for the warm refrigerator compartment, you want to check the damper assembly AP3581694 located in the air tunnel in the center of the back wall of the refrigerator. The damper opens and...
Forum: Washer Repair Yesterday, 09:10 AM
Replies: 1
Views: 15
Posted By Joe / APP Team
Plumberman, Since you didn't mention any error or...

Plumberman, Since you didn't mention any error or fault codes your problem is most likely in the motor hall sensor AP4211146 (Per Factory Sensor Is Not Available Separately Must Replace Motor) You...
Forum: Dishwasher Repair Yesterday, 08:30 AM
Replies: 1
Views: 24
Posted By Joe / APP Team
Camurra, We've attached the basic information for...

Camurra, We've attached the basic information for removal and installation of the AP4566983 door panel kit s/s. Good Luck,
Forum: Washer Repair 02-03-2016, 12:34 PM
Replies: 8
Views: 164
Posted By Joe / APP Team
Barnesrph, You're Welcome !!! Check those...

Barnesrph, You're Welcome !!! Check those pockets ... Good Luck,
Forum: Washer Repair 02-03-2016, 09:41 AM
Replies: 8
Views: 164
Posted By Joe / APP Team
Barnesrph, the attached file should have the...

Barnesrph, the attached file should have the information you need to remove the impeller and tub to check for the coins in the tub. Since you've had this issue before, you may want to start checking...
Forum: Oven Repair (including Ranges and Cooktops) 02-02-2016, 01:05 PM
Replies: 5
Views: 119
Posted By Joe / APP Team
Binderland, Don't know what to tell you. the...

Binderland, Don't know what to tell you. the building is designed to operate on 208 VAC, what the electrician told you is correct(your building was probably built back in the 70's) during the energy...
Forum: Oven Repair (including Ranges and Cooktops) 02-01-2016, 01:25 PM
Replies: 5
Views: 119
Posted By Joe / APP Team
Binderland, Your range is designed to operate...

Binderland, Your range is designed to operate properly on a minimum of 220 VAC. (110 VAC per leg), yes it will operate on lower voltage, but not properly. You may want to ask a neighbor if they have...
Forum: Washer Repair 02-01-2016, 07:37 AM
Replies: 8
Views: 164
Posted By Joe / APP Team
Rock, The creaking noise could still be due to...

Rock, The creaking noise could still be due to the mode shifter or possibly another component od the shifter assembly. We'll have to see once you get the washer dismantled and checked. To get to the...
Forum: Washer Repair 01-29-2016, 04:00 PM
Replies: 8
Views: 164
Posted By Joe / APP Team
Rock, Sounds like the problem is in the...

Rock, Sounds like the problem is in the "mode shifter" portion of the drive system. The mode shifter determines whether the agitate or spin cycle will operate. It is a combination of cams,gears and...
Forum: Oven Repair (including Ranges and Cooktops) 01-29-2016, 03:25 PM
Replies: 10
Views: 214
Posted By Joe / APP Team
Nealu, Denman is correct, the broil element does...

Nealu, Denman is correct, the broil element does cycle off and on in the pre heat and bake cycle, but it's only at 10 to 20 % of the cycle(you wont see it glow red, like the bake element).Start by...
Forum: Dishwasher Repair 01-29-2016, 03:13 PM
Replies: 1
Views: 57
Posted By Joe / APP Team
ernestcmjr, First thing to check is the disposal...

ernestcmjr, First thing to check is the disposal knock out plug. Make sure it was removed from the disposal flange when the units were installed. Then check and make sure there are no twists or sharp...
Forum: Dishwasher Repair 01-29-2016, 03:00 PM
Replies: 3
Views: 53
Posted By Joe / APP Team
RepairKing, You're Very Welcome !!! Glad we could...

RepairKing, You're Very Welcome !!! Glad we could help. Thanks,
Forum: Washer Repair 01-29-2016, 02:46 PM
Replies: 5
Views: 113
Posted By Joe / APP Team
Speckles, The dogs and grease will most likely be...

Speckles, The dogs and grease will most likely be sufficient, it doesn't sound like you'd be overloading the washer or doing a lot of laundry loads in succession. Next time, if in doubt ask, we're...
Forum: Oven Repair (including Ranges and Cooktops) 01-29-2016, 02:01 PM
Replies: 2
Views: 71
Posted By Joe / APP Team
Kathy, Yes it's repairable. It may need a new EOC...

Kathy, Yes it's repairable. It may need a new EOC / Control board AP4982698, but it is repairable. It could be a stressed circuit or relay for the broil element, or a degrading circuit in the control...
Forum: Washer Repair 01-29-2016, 01:53 PM
Replies: 1
Views: 67
Posted By Joe / APP Team
Hickman, a couple of "easy" checks to...

Hickman, a couple of "easy" checks to make, make sure the drain pipe is at least 38 inches high from the floor level. Then check the lid switch AP3180933. If the drain pipe is too low, the washer...
Forum: Dishwasher Repair 01-29-2016, 01:37 PM
Replies: 3
Views: 53
Posted By Joe / APP Team
RepairKing, Try this first, open the door, in the...

RepairKing, Try this first, open the door, in the center of the tub opening, just inside and in front of the door seal, you should find a hex head 5/16 inch screw. use a socket or nut driver and...
Forum: Washer Repair 01-29-2016, 01:15 PM
Replies: 5
Views: 113
Posted By Joe / APP Team
Speckles, Normally, I would recommend the...

Speckles, Normally, I would recommend the agitator cam repair kit [AP3094544], but you can probably get by with a few dabs of "Vaseline" or basic waterproof grease. Apply it to the lower cam...
Forum: Refrigerator & Freezer Repair 01-29-2016, 11:28 AM
Replies: 1
Views: 98
Posted By Joe / APP Team
ppudelek, Acess the display/control...

ppudelek, Acess the display/control boardAP3855824, use a multi meter and check for at least 13 VDC across pin 1 and pin 2 (red and brown wires) of the wire harness connector.
If you have the...
Forum: Dishwasher Repair 01-29-2016, 10:49 AM
Replies: 1
Views: 76
Posted By Joe / APP Team
Willindseay, You'll want to run the test mode,...

Willindseay, You'll want to run the test mode, and see if you're getting voltage to the wash motor/pump. You may have a faulty relay on the control board [AP4484676] Use the attached tech data sheet...
Forum: Oven Repair (including Ranges and Cooktops) 01-29-2016, 10:37 AM
Replies: 5
Views: 119
Posted By Joe / APP Team
Binderland, Since the elements (oven and cooktop)...

Binderland, Since the elements (oven and cooktop) operate at 220-240 VAC, and both are operating erratically, you'll need to use a multi meter and check for voltage changes (drops or increases) ...
Forum: Washer Repair 01-29-2016, 09:42 AM
Replies: 5
Views: 113
Posted By Joe / APP Team
Speckles, Yes is could be that the dogs are...

Speckles, Yes is could be that the dogs are wearing out and slipping. You shouldn't be able to turn the agitator clockwise at all. You will also want to remove the lower agitator and check the...
Forum: Oven Repair (including Ranges and Cooktops) 01-29-2016, 09:37 AM
Replies: 1
Views: 73
Posted By Joe / APP Team
Bill, It's most likely the upper oven relay board...

Bill, It's most likely the upper oven relay board [AP2127302]. Since the ovens program, and the broil element got red hot, chances are the bake element relay has failed and is not supplying the...
Showing results 1 to 25 of 500

 
Forum Jump


All times are GMT -7. The time now is 12:45 AM.

The content on this web site is for informational purposes only and is not intended to replace an on-site diagnosis from a qualified appliance service technician. By reading any content on this site you agree to AppliancePartsPros.com , Inc. disclaimer and Terms of Use.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2016, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17