Refrigerator & Freezer Repair

hurricanelt78 · #1 (**permalink**) 07-14-2008, 03:18 PM

I thought I might have a bad condenser fan motor. I tested voltage at wire harness connector at the motor and I have 13 volts from red to white wires and 13 volts from pink to white wires. So, I thought I had a bad motor and I replaced it but it is still turning very slowly, just like the old motor. What is the proper voltage I am supposed to have if it is different? Or maybe they just sent me a bad motor? And if so, what would be the resistance readings on the motor? Your assistance is greatly appreciated

abadfish66 · #2 (**permalink**) 07-14-2008, 03:52 PM

You have a bad control board, it is located behind the panel at the back of the refer, left side with 3 screws. Probably says technicians only on it.

hurricanelt78 · #3 (**permalink**) 07-15-2008, 07:19 AM

Thanks! I ordered the board last night...we'll see what happens

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
maytag top mount refrig motor condenser fan	april23	Refrigerator & Freezer Repair	1	10-14-2009 02:11 PM
Condenser Fan Motor not working	scieslicki	Refrigerator & Freezer Repair	1	09-29-2009 05:15 PM
Condenser fan motor	Rebound	Refrigerator & Freezer Repair	6	07-19-2009 03:17 PM
Condenser fan motor not working	Magilla Gorilla	Refrigerator & Freezer Repair	6	07-08-2008 06:16 PM
Main board and condenser motor	roch10	Refrigerator & Freezer Repair	4	03-06-2008 05:30 PM

GE refrigerator - bad condenser fan motor?

Refrigerator & Freezer Repair

I thought I might have a bad condenser fan motor. I tested voltage at wire harness connector at the motor