Rank: Member
Groups: Registered
Joined: 5/28/2010(UTC) Posts: 1
|
My ice maker quit making ice. Turns out the tab on the end of the ejecter bar had snapped off, thus allowing the drive gear to disengage from the motor. I bought a new ejecter bar, but was wondering if anyone could tell me how to recalibrate the sequence. It's sort of like a timing gear on an engine--it will go together 100 different ways, but it will only work one way. There is a red stripe on the gear, but there doesnt seem to be any obvious mark to line it up with. Anybody know where to set it?
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close