|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » bad board ? |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
05-23-2010, 08:19 PM
|
|||
|
|||
bad board ?
Model Number: pts25lhparww Brand: GE Age: 5 - 10 years
How can I verify that I have a bad board?
My compressor has no power to it, and my evaporator fan has low voltage, but will not spin. There are four wires to the fan motor, is this a multi speed fan as well? I verified power to the board with a digital multi meter, and it had 115v. When I touch the board the compressor relay will energize the compressor but then shut it off again shortly after I let go. ( I made sure the inlet power did not fluxuate when I touched the board ) The display panel in the fridge is set for -6 in the freezer, and 34 in the fresh food, but I only maintain a 56 degree box. When the compressor runs I do get frost on the evaporator coil so I am sure it is full of gas. Can anyone help me? Ads By Google Related Models 
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Main Controller Board or Display Board? | slarson252 | Refrigerator & Freezer Repair | 0 | 05-08-2010 07:16 AM |
| On Second Board | ECOMBS79 | Refrigerator & Freezer Repair | 1 | 12-07-2009 05:57 AM |
| Replacing circuit board but new board model is for dual heating elements | tinaott | Refrigerator & Freezer Repair | 1 | 10-15-2009 05:13 AM |
Linear Mode
