Rank: Member
Groups: Registered
Joined: 8/20/2016(UTC) Posts: 1
|
I removed my front panel on my water dispenser/ice maker to service a broken water paddle actuator. In the process, the wiring harness end (4) came loose. I watched your video on reconnecting it but my setup doesn't match your unit. The control board on the front panel is exposed (has no cover) and is secured by a plastic grid. There is a slot in the grid for the harness and there is what looks like the plastic connector immediately behind it. It appears to have a bar lock on the back of it that I can partially release. How do I thread the harness end marked 4 into the connector? Does it pass through the front of the connector and then lock in the back? I tried this and couldn't seem to get the harness end to go through. Or do I have to pass the harness over the top of the connector and thread it through the back where the lock is located. If this is what I need to do, should the side with the #4 and the contacts be feed in with the #4 showing or flipped over so the contacts enter the back of the connector face up?
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close