Hi, my refrigerator stopped working! The condenser coil was very dirty,I cleaned that. I ordered a new main control board control wr55x10942 and installed it but still no cooling? I have just replaced the starter relay wr07x10084 and the overload wr08x10025,and still not cooling!The relay clicks when I plug in the refrigerator and the compressor is vibrating?I have seen in other posts that if you shake the relay it should not rattle?The one I replaced and the new one both rattle when I shake them? could I have received a defective part from GE?I have run the diagnostics on it and everything checks out ok? I have checked the evaporator thermister, defrost heater with a dvm and there ok? I have checked for voltage on the j8 and j11 pins on the board and there is no voltage,if i check j9 and j11 there is 125 volts??????It seems like it's in defrost mode if j9 & j11 have power there?Could my compressor be bad?