Rank: Member
Groups: Registered
Joined: 12/28/2012(UTC) Posts: 2
|
Hi, I recently purchased a used Kenmore 106.8262580 upright freezer from an estate. The previous owner paid the $40/yr warranty since purchase (1988), and the compressor died around a year ago. Sears came out and replaced the compressor with an embarco, looks brand spanking new. Also new was the start relay.
Problem is, yesterday, the freezer was off and wouldn't go back on. Tried swapping out different plugs, etc., moving the thermostat. Compressor was warm but wouldn't kick on. After disconnecting everything for about two hours, I plugged it back in and it's been working fine since. This is the first time in about three months that this has happened.
Any thoughts on what may have caused this? Is there a way to check common problems that may be associated with this? I have a multimeter. Thanks! Adam
|
|
|
|
Rank: Advanced Member
Groups: APP Team
Joined: 2/12/2012(UTC) Posts: 5,556
|
Hi.
You really can't check anything if the unit is working fine.
Simon.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC) Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
Wait till it stops again, then tap the cold control 4389248 and see if it comes on. This assumes everything has stopped running when it fails.
|
|
|
|
Rank: Member
Groups: Registered
Joined: 12/28/2012(UTC) Posts: 2
|
Thanks, I'll make sure to do that. In the meantime, the meat stays in a more reliable freezer!
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close