|
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Whirlpool Refrigerator #ED25DQXBW00 /Ice Maker not freezing properly |
|
|
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
|||
|
Model Number: ED25DQXBW00 Brand: Whirlpool Age: More than 10 years
The problem I'm having with this icemaker is that some of the cubes are frozen properly while approx. half come out as as an ice shell. The cubes are hollow - basically a thin shell of ice. Any suggestions on a cause and repair.
Thanks CP Ads By Google Related Models |
|
See inside of your appliance - diagrams and part photos for virtually every model. powered by AppliancePartsPros.com |
|
|||
|
It sounds like you're losing water pressure to the refrigerator. I've seen this happen before with the self piercing saddle valves. The rubber gasket under the piercing needle starts to break apart and occasionally gets caught in the hole. Shut the valve off and disconnect the water line then open it again and check the water pressure. Get a bucket ready.
__________________
Ricks Appliance Repair |
|
See inside of your appliance - diagrams and part photos for virtually every model. powered by AppliancePartsPros.com |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
|
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Whirlpool Ice Maker Water Fill Tube Freezing Up | n4cer4u | Refrigerator & Freezer Repair | 4 | 11-12-2012 03:17 PM |
| freezer & refrigerator not cooling properly, ice maker not making ice - | debrawishom | Refrigerator & Freezer Repair | 0 | 06-16-2011 09:09 AM |
| Whirlpool refrigerator not freezing/cooling | grumpy225 | Refrigerator & Freezer Repair | 2 | 11-27-2009 02:22 PM |
| refrigerator not cooling or freezing properly. | Bill K | Refrigerator & Freezer Repair | 4 | 08-09-2008 09:06 AM |
| Whirlpool Refrigerator not freezing or cooling | KPW | Refrigerator & Freezer Repair | 0 | 08-13-2007 05:38 AM |