Rank: Member
Groups: Registered
Joined: 10/26/2012(UTC) Posts: 3
|
I replaced the water dispenser actuator and when I reconnected the ribbon cable for power it automatically wants ice to dispense. I cannot leave the unit connected now because of this problem. I actually damaged the initial ribbon cable when I did the first repair. The ice dispenser actuator is not depressed. Anyone else run into this please help. I hope its not the circuit board:( :(
|
|
|
|
Rank: Member
Groups: Registered
Joined: 10/26/2012(UTC) Posts: 3
|
Bumping this up. Anyone please help
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
Make sure the wire harness is not switched around. Check the micro switch (#38A at the diagram). If there is nothing wrong, replace the dispenser power board. - The micro switch Part number: 241689101
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close