|
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Older kenmore fridge Supco Pushon pro41 |
|
|
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
|||
|
Model Number: 106.7698380 Brand: Kenmore Age: More than 10 years
need help with supco pro41 push on. There are 2 male prongs marked "L" what to they mean and 2 other prongs marked "cap" with a single metal sleeve around both of them. Then i have a white wire and a red wire coming off the fridge where do those go? how can i jump the condenser to test it as well?
Ads By Google Related Models |
|
See inside of your appliance - diagrams and part photos for virtually every model. powered by AppliancePartsPros.com |
|
|||
|
You will need an ohmeter to wire this up. Be informed this device has poor thermal and overload protection. I have seen these devices burn out a compressor! Be informed, this device may burn out the compressor if the compressor is not the "standard" compressor start winding pin configuration on the bottom, left.
A very good start device is available WR09X10106, but you need to test the compressor first to verify compatability.
__________________
- Last edited by richappy : 10-26-2012 at 02:49 AM. |
|
See inside of your appliance - diagrams and part photos for virtually every model. powered by AppliancePartsPros.com |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
|
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Older Kenmore dryer not heating | jttaylor | Dryer Repair | 0 | 02-22-2012 07:18 AM |
| Older Kenmore Dryer | Sierra Steve | Dryer Repair | 0 | 10-19-2011 02:37 PM |
| Can I test a Supco 3n1 with a multimeter? | Pickngrin | Refrigerator & Freezer Repair | 1 | 09-26-2010 10:40 AM |
| Older Kenmore Leaking in front | Miculiz | Washer Repair | 5 | 03-21-2010 02:46 PM |
| Older Kenmore runs....sometimes | krazeeonu | Refrigerator & Freezer Repair | 1 | 11-01-2008 06:57 AM |