Rank: Member
Groups: Registered
Joined: 8/3/2012(UTC) Posts: 1
|
I am replacing the water dispenser actuator in elite side-by-side (mdl# 253.445096). What I cant figure out is how to reinsert the water tube into the dispenser housing during re-assembly (no clearance)? Is it possible to replace the 6 inches (or so) at the connection visible in the dispenser with a longer section and then snip the excss at the spout? What is the correct procedure?
Thanks! Tracy
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close