Rank: Member
Groups: Registered
Joined: 5/9/2012(UTC)
Posts: 2
|
Just replaced and installed a new start capacitor and overload AP4079373 (67005560) module, and refrigerator is back up and running!
When trying to re-install the retaining clip, I noticed it held the start capacitor and overload module at an odd angle (not level) to the compressor. In fact, the compressor would not kick in with the retaining clip installed - due to the angle and likely bad contact. The module currently is plugged in firmly and is running fine. Is the retaining clip needed?
Thanks in advance for your help.
|
|
|
|
|
|
Rank: Advanced Member
Groups: APP Team
Joined: 2/12/2012(UTC)
Posts: 5,556
|
Hi.
Basically, retainer clip is needed when you are moving the fridge.
Just keep in mind to check it after the move.
Thank you.
Simon.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 5/9/2012(UTC)
Posts: 2
|
Thanks for the confirmation! I appreciate it.
|
|
|
|
|
|
Rank: Advanced Member
Groups: APP Team
Joined: 2/12/2012(UTC)
Posts: 5,556
|
|
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
