|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Board problems pain in the Butt |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
08-10-2007, 01:19 AM
|
|||
|
|||
Board problems pain in the Butt
Model Number: GE sxs gss26LSRDSS Brand: GE Age: 1 - 5 years
I had a light go out in the dispenser .. replaced the light and next day or so went out again but this time whole board went dead...
Im assuming the board is bad and would like to know how to remove the board.. dont see how to get at the control board .. looks like it all one piece to replace .. ALSO... Is there something that causes this to happen? Dont want to fix it and have it just blow out again. How do i get this loose without damageing anything.. is there hidden screws somwhere or does it just snap or clip in??? below is what it looks like and the replacement for it.. looks just like the pic. thanks for ANY help from any genius's out there heres what i looked up for the board     
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Circuit board replacement | tobrouhard | Refrigerator & Freezer Repair | 5 | 08-16-2007 06:24 AM |
| Sharp R-310FW display board | Clark-bar | Microwave Repair | 1 | 08-01-2007 04:01 PM |
Linear Mode
