Rank: Member
Groups: Registered
Joined: 5/8/2011(UTC) Posts: 1
|
Defrost cycle is controlled by the mother board. How do i start the defrost cycle to see if the defrost heater is working.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC) Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
When the compressor is running, remove the back motherboard cover, then unplug the fridg and remove the bottom 3 pin power connector. Locate the connector mating pins on the motherboard labeled def. and line. Put a wire jumper between these pins on the connector, plug in fridg, then check for defrost action. If no defrost, most probable problem is the defrost heater.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close