Rank: Member
Groups: Registered
Joined: 12/23/2010(UTC) Posts: 1
|
I installed a new ice cube replacement auger - GEH WR17X11939 today. Every thing is fine except I cannot remember if the ice blades - part #334 (3) that remove and/or crush the ice were staggered or more or less in a pattern. The shaft is rectangular so there are only two positions to select when sliding them back onto the new shaft. The exploded parts diagram shows the three blades close to alignment. The operation does not crush ice systematically now but never was real good. Is that correct? Dan
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close