Refrigerator & Freezer Repair

Julie Riggleman · #1 (**permalink**) 10-06-2008, 11:44 AM

We just replaced the door gasket this weekend; the door doesn't meet with the face when you close it unless you give it an extra hard push to engage the magnet inside the seal.

In looking at the door, it appears the gap between the box and the door itself is wider at the bottom than the top. How do I even the gap so the door can close correctly?

Drags1998 · #2 (**permalink**) 10-06-2008, 05:13 PM

You don't, the seal will stretch out, If it needs help, use a hair dryer to HEAT the seal to soften it and it should be better. after a short period of time it will be OK.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Refrigerator door closer, lower cam and cam-door	aroffe	Refrigerator & Freezer Repair	0	08-28-2008 10:54 AM
Refrigerator door	STEVE DOE	Refrigerator & Freezer Repair	0	02-15-2008 11:41 AM
Removing Refrigerator Door	mauriced	Refrigerator & Freezer Repair	0	12-31-2007 09:31 AM
Microwave Oven Door Alignment	doityourselfer_ed	Microwave Repair	1	12-21-2007 05:59 PM
Refrigerator Door Problem	dfrueh	Refrigerator & Freezer Repair	0	07-27-2007 06:54 AM

Refrigerator Door Alignment

Refrigerator & Freezer Repair

We just replaced the door gasket this weekend; the door doesn't meet with the face when you close it