Rank: Member
Groups: Registered
Joined: 8/5/2010(UTC) Posts: 1
|
I had my mother board replaced about 9 months ago. Appoximately 2 months later, my ice maker stopped dispensing cubes. The motor is running but the device that turns to dispense the cubes is not functioning. Any advise would be greatly appreciated.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 9/10/2007(UTC) Posts: 9,586
Was thanked: 2 time(s) in 2 post(s)
|
If your auger motor is not turning in the back, it's probably bad, just remove the back panels to check, might be frozen/rusted up.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close