|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » GE Profile Ice cube size |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
08-11-2008, 05:43 PM
|
|||
|
|||
GE Profile Ice cube size
Model Number: PSS25MGMB WW Brand: GE Age: 5 - 10 years
Ice has always been difficult to dispense from this fridge. The auger spins and pushes ice, but when it gets the cubes to the front they shoot out like the fridge is possessed!
 The ice cubes seem quite large which may be the problem. Is there a way to reduce the amount of water that flows into the ice cube trays? Or is there a different solution to help the ice dispense without scaring everyone in the house? -Kurt     
|
|
08-12-2008, 05:44 PM
|
||||
|
||||
|
Hi Kurt,
There are no adjustments possible on this ice maker. It could happen if incoming water is too cold or in case of failure of the ice maker control board and/or thermostat. The ice maker is not repairable and has to be replaced. - The part number for the new ice maker is AP4345120 Here are the break down diagrams for the GE refrigerator Model PSS25MGMBWW Gene.
__________________
Professional appliance repair in Los Angeles, California.
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| No fill on small load size | crosstalk | Washer Repair | 0 | 05-19-2008 08:26 AM |
| Ice Cube Maker | Johnbay | Refrigerator & Freezer Repair | 1 | 03-25-2008 01:58 PM |
| Left Front Duel size burner is on 100% or off, | desanmr | Oven Repair (including Ranges and Cooktops) | 1 | 03-21-2008 05:01 PM |
| Standpipe size and drain flow rate | suntzujr | Washer Repair | 1 | 02-12-2008 01:01 PM |
| Kenmore Dryer-apartment size | Mary Bennetts | Dryer Repair | 1 | 02-12-2008 11:29 AM |
Linear Mode
