Refrigerator & Freezer Repair

larryafoster · #1 (**permalink**) 07-25-2008, 02:29 PM

I need to know how to disassemble the ice/water dispenser in the door,
to replace a broken switch. Do I pry off the cover? or do I go in through
the back, removing many screws?? as well as the door seals.

thanks in advance!!

larry foster

abadfish66 · #2 (**permalink**) 07-25-2008, 02:55 PM

The front panel that says ice/water etc, pops right off, after that is removed, there are 4 screws that hold the assy in place, remove those, remove the rubber pad, by pulling it, it is attached to a square plastic piece that unsnaps, disconnect the wiring and you can get to the switch.

larryafoster · #3 (**permalink**) 07-25-2008, 03:44 PM

thanks, that works great!!!!

a thousand thanks.

Larry

abadfish66 · #4 (**permalink**) 07-25-2008, 03:48 PM

Not a problem, good luck

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GE Profile Arctica Not dispensing water	Maribel Lumangdag	Refrigerator & Freezer Repair	3	03-14-2008 09:45 AM
water actuator on water dispenser	sixkings	Refrigerator & Freezer Repair	1	01-07-2008 10:33 AM
GE Profile Not Getting Water	JeffZ	Dishwasher Repair	0	12-01-2007 01:31 PM
ice dispenser working...water dispenser not	rishuk	Refrigerator & Freezer Repair	0	09-25-2007 04:03 PM
GE Profile Arctica Water Line	taximomuv3	Refrigerator & Freezer Repair	0	08-14-2007 04:31 PM

GE Profile ice/water dispenser

Refrigerator & Freezer Repair

I need to know how to disassemble the ice/water dispenser in the door, to replace a broken switch. Do