AppliancePartsPros.com
»
Appliance Repair Help
»
Washer Repair
»
Matag Epic Z shuts off after pressing start button
Rank: Member
Groups: Registered
Joined: 10/31/2013(UTC)
Posts: 5
|
It also appears that the CCU has numerous part numbers. So far I have found 4 that appear to be compatible with this machine (W10246302, W10205976, W10205839 and W10525356). Can you verify this is correct?
|
|
|
|
|
|
Rank: Advanced Member
Groups: Moderators
Joined: 7/14/2010(UTC)
Posts: 5,222
Was thanked: 1 time(s) in 1 post(s)
|
Originally Posted by: Dblboinger  Joe...did you mean 9-10k ohms? That is what my sensor measures and I can se the value change if you submerge it in warm (reading decreases) or cold water (reading increases). Dblboinger, You're correct, I guess I forgot to add the K ohms to the previous post. Your resistance readings in general are correct, the resistance should increase as the water temperature is cool, and decrease as the water temperature increases. Now you need to do the same test at the wire harness connector at the TH2 terminal on the CCU. (You may need to insert a metal paper clip, large needle or pin into the connector to test the readings at the harness connector. If you get the same results, this will tell you the sensor and wire harness are operating properly, and you will need the CCU W10525356 Part number: AP5781703
|
|
|
|
|
|
AppliancePartsPros.com
»
Appliance Repair Help
»
Washer Repair
»
Matag Epic Z shuts off after pressing start button
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
