Post a reply - Appliance Repair Forum - Free Service from Appliance Parts Pros

Last 10 Posts (In reverse order)
denman	Posted: Friday, April 9, 2010 5:44:44 AM(UTC)
	[COLOR="Blue"]Was this condition destructice or should I be able to reset the fault once I release the service lockout?[/COLOR] It should reset unless you have a bad oven temperature sensor. Re: open or a bad connection in which case the unit will think it is still over temp. [COLOR="Blue"] (should I be able to release the lockout from within this action, or from just a hard reset?)[/COLOR] Yes or at least I think it should. I am not 100% sure on this. You may find the following useful http://www.applianceaid.com/erange.html
	THIS FORUM IS DEAD!!!!!!!
Jim Lane	Posted: Thursday, April 8, 2010 3:03:33 PM(UTC)
	denman, Thank you for the quick responce this is exactly the data that I needed. The fault code 1d11 = Runaway temp, door unlocked (single cavity or upper oven) Was this condition destructice or should I be able to reset the fault once I release the service lockout? Service Mode: (should I be able to release the lockout from within this action, or from just a hard reset?) Follow procedure below to use the Test Mode. 1. Press *SETUP* pad. 2. Press *DOWN ARROW* pad three times until *SERVICE* is displayed. 3. Press *SERVICE* pad. 4. Press and hold *BACK* and *ENTER* pads for 5 seconds. 5. Press *SERVICE* pad. NOTE: If the oven cavity temperature is greater then 400F, the Test Mode cannot be activated or will abort the mode if activate NOTE: Once the Service Mode is activated the control will activate the relay until the pad is pressed again. I am going to check it again tonight. Thank you for all of your help. Jim
denman	Posted: Thursday, April 8, 2010 4:10:17 AM(UTC)
	Here are your parts Replacement parts for JENN-AIR JMW8527DAW Walloven - S/c Mwave Ele \| AppliancePartsPros.com Here is the tech sheet http://www.servicematters.com/maytag_library/docs/16022823.pdf And a manual http://www.servicematters.com/maytag_library/docs/16022821.pdf Try removing power from the unit for half an hour or so to see if it will reset. If not it looks like this is a door switch error so I would start there re: a bad switch or wire etc.
	THIS FORUM IS DEAD!!!!!!!
Jim Lane	Posted: Thursday, April 8, 2010 1:27:51 AM(UTC)
	I have a Jenn-Air Model# JMW8527DAW electric oven that has stopped working that I am trying to diagnose, if I try to use the oven in either Bake of Broil the display reads FEATURE NOT AVAILABLE PRESS HELP and "id 11" is displayed to the right of the clock. When I press help the next display shows Fault Detected and 2 other options I cannot remember but when I open Fault Detected it says that I can press Cancel to reset the oven but this does nothing Reading the users manual in the troubleshooting section it read: If the same operation is attempted before having the wall oven repaired, the message “Feature not available” will appear. The feature will remain inoperable until service is obtained. How do I reset this service lockout and what caused this oven to stop working? is "id 11" a service code? I have found the User Manual but I cannot find a Service Manual for this unit. Thank You for your help. Jim

Notification