|
On bottom in rear, to the left, is the heater assembly. Just check it for broken wires or put a meter on it. Anything without continuity is the problem. When checking parts remove one of the wires so as not to get a backfeed(false reading)I am assuming you have the machine disconnected from power source.
|
|
start here remove the front after wards and get the drum out.
|
|
Actually, just take off the bottom panel, and look all the way in the back on the bottom left side, and there will be the element housing. There is 2 screws holding it in, and there it is. If you need me you can reach me at my web site at ApplianceEducator.com Tom
|
|
My dryer has been performing fine until a few days ago when I realised that the heat had stopped working. I need to be able to find out which part I need to replace therefore I need a starting point.
Where do I open the machine up and should I be able to spot which part needs replacing.... I think there are three possiblities
a. the coil b. burnt wire connector c. thermostat
Please help
|