|
Another issue is that the neighboring area of a burner is also getting warm. Usually, the round area of a burn is hot but the vicinity is cool. Isn't it?
|
|
Now, the unit works fine other than one problem. The downdraft vent speed does not change. My unit has "low - high" 2-speeds. The speed on the LCD panel changes, but the actual fan speed remains low. I assume there is a part controlling the speed of the motor. Where is it and what's the part number? I hope this time I get some help.
|
|
Whirlpool Range/Stove/Oven Power Cord PT500
|
|
I bought Whirlpool power cord that was exactly the same as the one on my Jenn-air, and installed it. Not it works fine.
|
|
The problem is the burnt power inlet. At the lower left side of the back of the unit, there is power in-let. 220 Volt electric chord is divided into three lines: white, black, and green. The green line was burnt and disconnected. So, I need a new power chord. Could you tell me the part number?
|
|
My down-draft Jenn-Air (JES9900BAS) range/oven's LED lights up and works. But, the oven does not heat up at all, and the burners do not heat up or light up the red heat-on button.
What might be the problem here.
Taeseoplim.
|