|
|
Yes it is soldered to the board.
It may be a bad relay but also could be the electronics that control the relay
|
| THIS FORUM IS DEAD!!!!!!! |
|
|
thanks
Yes, I check them o ohms,
I check on close circuit, Item by item, The element is 13 ohms, the termal sensor is ok.
I think it is the relay. So it is weld on board.
Tahnks
|
|
|
Here are your parts' An AYW3 does not come up so the parts are for an AYW2. They are probably the same. Parts for Whirlpool WDF750SAYW2 / Dishwasher - AppliancePartsPros.comSee the attachment for your tech sheet. Did you check the hi-limit thermostat (item 25 in section 05).? It should be 0 ohms. Also it might be a good idea to check the heater circuit at the control board. P4-3 to P4-4. This will check the heater, the hi-limit and the wiring. Also check the thermistor resistance, see the tech sheet.
|
| THIS FORUM IS DEAD!!!!!!! |
|
|
I,
I need Help!!!
Yesterday I have to replace my motor in my dishwasher, find the part, change it and splash a gain in the machine, So now I have an other problem, I dont have anay heat on the element,
I have 13 oms for the element, I test the wiring to the control box, ok.
This morning I have pull out again my dishwasher just for checking if everithing is pluged, all ok.
What I miss!!!
:eek:
Thanks
|
