HI Thanks.. yes i went thru these codes already.. when i run the test ( after clearing the code ) as i mentioned there is no error codes after these tests ..


Here are some more details :

The GE front load washing machine. model :gbvh5200j0ww
It stopped washing , spinning ( may be i overloaded with cloths .. i dont know..) .i have already checked the foll:

1) Belt behind is ok. I can rotate the drum by hand in both dirs..
2) cleaned up washer pump filter
3) replaced control inverter ( based on some technicians advice) and still the issue is there (so it is not a problem of inv board)

I did see an error code e46 ( and this for before running the diagnostic tests) but was not sure if these are from old test or something .. so i cleared these up before conducting the tests and re tried :
a) the test t10 ( tumble test mode) , it rotates 5 times in one dir and stops. No tumbling in opposite direction. But i dont see updated error code .. it shows e00 ( meaning no error code stored)

b) test t11 ( spin test). It shows 0 on the panel and the drum does not spin ( the motor does not rotate .. i checked from behind the machine). There is some draining pump sound ..that is it ( and once again he error code does not get updated ..

Anyways there is definitely issues with rotation etc.. I have not checked the ohms etc of the motor yet to test further ( need to buy the multimeter etc)..

Also the tumble test moves the drum in one dir , so am not sure if the motor is the issue ( as it does notate in one dir 5 times..)

Thanks again
Vishy

Having similar issue. Having ge model starting ith GBVH....
In Tubmle test rotates 5 times in same dir.
No spin, hear sound like draining.. hen i run the test i don't see error codes though. The first time there were some error codes like e46 but i cleared them first before running these tests after which i dont see updated codes..just shows e00. But the issues are there. No wash, spin .. having hard time..

Pl post if you were were able to find a soln..
Thanks
Vishy