Post a reply - Appliance Repair Forum - Free Service from Appliance Parts Pros

Welcome Guest! To enable all features please Login or Register.

Notification

Error

Post a reply

From:

Message:

Maximum number of characters in each post is: 32767

Font Color Font Size

[quote=goingjumping;800142]I have a Kenmore dish washer that seem to run and work but about 10 min into its cycle the water is over flowing on to the floor.  If I open the door water seems to still be flowing out of the fill spout on the left side. 

If I hit cancel and drain water still flows out for a little while but the washer does drain all the water from the base. 

Is there some kind of fill valve that is jamming or not sensing  the cycles?   

Greg[/quote]

Security Image:

Enter The Letters From The Security Image:

Preview Post Cancel

Last 10 Posts (In reverse order)
Gene	Posted: Monday, February 18, 2013 1:37:22 PM(UTC)
	Hi Greg, Sounds like the problem is a bad water inlet valve under the dishwasher. Remove the toe panel and you'll access it. - The water inlet valve Part number: W10158389 Gene.
goingjumping	Posted: Sunday, February 17, 2013 3:03:47 PM(UTC)
	I have a Kenmore dish washer that seem to run and work but about 10 min into its cycle the water is over flowing on to the floor. If I open the door water seems to still be flowing out of the fill spout on the left side. If I hit cancel and drain water still flows out for a little while but the washer does drain all the water from the base. Is there some kind of fill valve that is jamming or not sensing the cycles? Greg

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close