|
Hi.
Unplug the dryer. Open the control panel and install jumper between BK-R on the timer. Turn the power on.Run the dryer. Check if that makes any difference.
Next thing plug the dryer into another outlet and run it.
Post the results.
Simon.
|
|
Hi.
To check the voltage in the outlet insert the voltmeter's probes into the outlet.
Simon.
|
|
Yes it does and im not quite sure on how to check the voltage?
|
|
Hi.
Does the motor runs when the dryer is not heating? What is the voltage at the outlet?
Simon.
|
|
Well i found the problem, If i flip the breaker the dryer will work on its first cycle. Than nothing. Flip the breaker again and same thing. Do i have a bad breaker or not enough power getting to the dryer?
|
|
Post the results.
Simon.
|
|
I took the sensor out to check it, but i will put it back in and test it tonight
|
|
Hi.
Check the flame sensor when ever the ignitor fails to glow. Did the burner ignite right after you checked the sensor?
Simon.
|
|
The flame sensor tested okay at room temperature but i have no way of checking it at 1500 degrees
|
|
|