Post a reply - Appliance Repair Forum - Free Service from Appliance Parts Pros

Last 10 Posts (In reverse order)
denman	Posted: Friday, July 20, 2012 2:05:01 AM(UTC)
	Depends on your definition of easy. If you click on a part's picture a new page will open often with more views and a Q&A section. This often has install info. Looks like you remove the rear cover to get at it, Then it is either held in by a few screws or by clips. If clips be careful that you do not break them. You may also need a new overlay (Item20A in Section 1) Looks like it is a peel and stick. Just be sure to unplug or flip the breaker when working on it. If wires can go a couple different places be sure to swap one at a time or make a list/diagram where they go.
	THIS FORUM IS DEAD!!!!!!!
Johnwg	Posted: Thursday, July 19, 2012 5:17:23 PM(UTC)
	Originally Posted by: denman OK, so the unit is getting 240 volts therefore it is either a wiring problem or more likely the control board is shot. Thanks Denman, is it an easy swap to change the control board?
denman	Posted: Wednesday, July 18, 2012 3:00:20 AM(UTC)
	OK, so the unit is getting 240 volts therefore it is either a wiring problem or more likely the control board is shot.
	THIS FORUM IS DEAD!!!!!!!
Johnwg	Posted: Tuesday, July 17, 2012 4:46:29 PM(UTC)
	Originally Posted by: denman Here are your parts Replacement parts for Frigidaire FEF366EMD Frigidaire/range \| AppliancePartsPros.com Here is the wiring diagram http://manuals.frigidaire.com/p...pringfield/316441437.pdf Do the stove top elements work? Does the broil (upper) oven element work? Odds are that the control board is toast. I would remove the rear cover and check that the wiring to the elements is OK. The upper heating element does not work, but the stove top works fine.
denman	Posted: Monday, July 16, 2012 1:59:27 AM(UTC)
	Here are your parts Replacement parts for Frigidaire FEF366EMD Frigidaire/range \| AppliancePartsPros.com Here is the wiring diagram http://manuals.frigidaire.com/p...pringfield/316441437.pdf Do the stove top elements work? Does the broil (upper) oven element work? Odds are that the control board is toast. I would remove the rear cover and check that the wiring to the elements is OK.
	THIS FORUM IS DEAD!!!!!!!
Johnwg	Posted: Sunday, July 15, 2012 1:08:39 PM(UTC)
	I replaced the lower heating element in my oven after some fireworks - the element popped in two, and burned a hole in the lower pan. After replacement, it's not heating. Could it be the oven control board or the temp sensor? There is no thermal fuse in this unit. Model #FEF366EMD. Any help is appreciated.

Notification