Post a reply - Appliance Repair Forum - Free Service from Appliance Parts Pros

Last 10 Posts (In reverse order)
Simon / APP Team	Posted: Monday, December 10, 2012 10:23:35 AM(UTC)
	Without doing the test my best guess it's a bad control board Part number: 67006743 Located in the dispenser 07-Fountain parts for Maytag MZD2663KEQ - AppliancePartsPros.com Good luck. Simon.
jmclanton	Posted: Monday, December 10, 2012 9:46:19 AM(UTC)
	Originally Posted by: Simon / APP Team Hi, Julie. I asked you to check the actual voltage at the auger motor wile it's running. You need to use the voltmeter. Simon. Don't have one. Julie
Simon / APP Team	Posted: Monday, December 10, 2012 9:32:34 AM(UTC)
	Hi, Julie. I asked you to check the actual voltage at the auger motor wile it's running. You need to use the voltmeter. Simon.
jmclanton	Posted: Monday, December 10, 2012 8:31:59 AM(UTC)
	Originally Posted by: Simon / APP Team HI. Can you check what is the voltage at the auger motor? Simon. 110-120 V is what is on the sticker for the auger motor. Julie
Simon / APP Team	Posted: Monday, December 3, 2012 9:42:14 AM(UTC)
	HI. Can you check what is the voltage at the auger motor? Simon.
jmclanton	Posted: Saturday, December 1, 2012 2:36:44 PM(UTC)
	It will run for about 20 seconds than stops but If I remove the ice bin and hold the button down it will run longer.
Simon / APP Team	Posted: Tuesday, November 27, 2012 2:32:03 PM(UTC)
	Hi. Did it work for some time? Simon.
jmclanton	Posted: Tuesday, November 27, 2012 8:35:17 AM(UTC)
	Hi, I replaced the capacitor Part number: 65889-4 that was recommended but still having the same problem, it stops dispencing ice. Any other suggestions? Thank you, Julie M. Clanton:confused:
Simon / APP Team	Posted: Tuesday, May 29, 2012 12:58:06 PM(UTC)
	Hi. Check the run capacitor Part number: 65889-4 The info is on the capacitor. Here are the breakdown diagram and Freezer compartment replacement parts for Maytag MZD2663KEQ REF - SXS/I&W \| AppliancePartsPros.com Thank you. Post thew results. Simon.
jmclanton	Posted: Tuesday, May 29, 2012 10:03:40 AM(UTC)
	Ice stops dispencing, I have replaced the auger motor & hex cap (looked a litte worn). I removed the ice bin and ran the auger motor with door open and the motor runs fine for about 10 seconds but starts to bog down and stops running. After a couple mintues of letting is sit it will start up and then quit again. This is a new auger motor I purchase from Parts Select a few weeks ago and still can't figure out what is wrong with it not dispencing the ice properly. Please advise.

Notification