Customer Support 7 days a week

Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

Post a reply
From:
Message:

Maximum number of characters in each post is: 32767
Bold Italic Underline   Highlight Quote Choose Language for Syntax Highlighting Insert Image Create Link   Unordered List Ordered List   Left Justify Center Justify Right Justify   Outdent Indent   More BBCode Tags
Font Color Font Size
Security Image:
Enter The Letters From The Security Image:
  Preview Post Cancel

Last 10 Posts (In reverse order)
richappy Posted: Monday, September 19, 2011 7:09:57 AM(UTC)
 
You need to put a gauge on the low side of the compressor tubing to see if the compressor is drawing a vacuum, if so, the compressor is damaged from compressing non-compressables. Usually the leak is from the evaporator which makes the fridg too expensive to repair.
jpm01609 Posted: Monday, September 19, 2011 5:43:18 AM(UTC)
 
Originally Posted by: richappy Go to Quoted Post
The tape is to distribute heat evenly to prevent refrigerant boiling noises as it turns into a gas in the evaporator.
The slight frost is indicative of a refrigerant leak, usually terminal.



a) would the tape be something that they would have installed at the factory?

b) do ytou think I lost any refrigerant?

c) After it dried off, I taped it over with duct tape and the internal freezer temperature (2 days later) has gone from 42F down to around 34-35F (still not below 32F)

d) do you think the fridge has ANY hope? it's been barely used
richappy Posted: Saturday, September 17, 2011 3:11:56 PM(UTC)
 
The tape is to distribute heat evenly to prevent refrigerant boiling noises as it turns into a gas in the evaporator.
The slight frost is indicative of a refrigerant leak, usually terminal.
jpm01609 Posted: Friday, September 16, 2011 9:50:56 AM(UTC)
 
I rent out apartments to college kids. I bought this fridge at Lowes in the Scracth and Dent dept 3 or 4 years ago.

The unit gets low usage and non during the summer. Around June 1 of this year, I unplugged it and left both doors open. (this is a 16.5 ft--freezer top )

Recently the tenants complained that the freezer was too warm. I took it open and did a ton of research online too.

Last night I opened the back to check for frosting and sure enough there it was. So I left the unit unplugged and the doors open all night.

Today I examined the area where the frosting occurred. It happens to be the point where the defrost heater attaches to a thin (1/8"?) copper feed tube above it. But the weird thing was there was a 2 inch piece of tape with a soft black asphalt-like tape of the area where the joint is.

a) Would it have come from the factory like this?

b) Did I buy a reconditioned unit and not know it?

c) If it is a leak in the refrigerant or in the coil, is it a repair I can do myself?