|
|
| THIS FORUM IS DEAD!!!!!!! |
|
There are no water marks on the motor. The motor doesn't make any sound. I checked the voltage and it showed ok on one wire but there are 4 more that entering the motor and I don't have voltage on any of them. I cannot find the electrical schematic/control drawings. Is it on the back of the machine? How can I verify a bad motor without taking it out?
|
|
Sounds like the pump is not working. Remove the toe panel and check for a water marks on the motor. If there are any, then the pump & motor assembly has to be replaced. Start the dishwasher and see how the motor acts. - The part number for the pump & motor assembly is AP3776341Here are the break down diagrams for the Kitchen Aid dishwasher Model KUDR24SEBL1Gene.
|
|
The cycle monitor light on the front panel goes thru every cycle. The water fills on the and does not drain. There is no additional action or noise inside? When I open the door after the dry cycle the water is in the bottom and the soap holder is open with the soap in it.
|