Post a reply - Appliance Repair Forum - Free Service from Appliance Parts Pros

Welcome Guest! To enable all features please Login or Register.

Notification

Error

Post a reply

From:

Message:

Maximum number of characters in each post is: 32767

Font Color Font Size

[quote=jrhamilton;240191]I replaced the klixson overload, start relay and run capacitor.....amp probe shows about 2 amps at start...but still overheats and trips the overload after a few seconds.  The ohms readings are great between common and start and run and no grounds are read either.
Would a hard start kit be ok? It has an Embraco compressor, EMY60HSC, which i believe is 0.176 hp.
The Supco kit i was considering is an RCO810.
OOPs...looks like the Embraco is a 600 Btu/h(thermal) so that would make the conversion to about 175 watts and closer to a 1/4 hp....[/quote]

Security Image:

Enter The Letters From The Security Image:

Preview Post Cancel

Last 10 Posts (In reverse order)
jrhamilton	Posted: Monday, July 12, 2010 3:27:51 PM(UTC)
	I replaced the klixson overload, start relay and run capacitor.....amp probe shows about 2 amps at start...but still overheats and trips the overload after a few seconds. The ohms readings are great between common and start and run and no grounds are read either. Would a hard start kit be ok? It has an Embraco compressor, EMY60HSC, which i believe is 0.176 hp. The Supco kit i was considering is an RCO810. OOPs...looks like the Embraco is a 600 Btu/h(thermal) so that would make the conversion to about 175 watts and closer to a 1/4 hp....

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close