Post a reply - Appliance Repair Forum - Free Service from Appliance Parts Pros

Welcome Guest! To enable all features please Login or Register.

Notification

Error

Post a reply

From:

Message:

Maximum number of characters in each post is: 32767

Font Color Font Size

Security Image:

Enter The Letters From The Security Image:

Preview Post Cancel

Last 10 Posts (In reverse order)
ThatGuy	Posted: Friday, December 23, 2016 11:05:26 AM(UTC)
	You replaced the belt switch? This part? Whirlpool 279782 Broken Belt Switch Kit - AppliancePartsPros.com Did your old switch have just two terminals on it and the new one had three? Watch this video. Especially after 4:42 up to 5:50. Dryer Broken Belt Switch Kit (part #279782) - How To Replace The wires should be on the common and normally closed terminals.
FixHR	Posted: Friday, December 23, 2016 7:19:17 AM(UTC)
	Just replaced the motor in above dryer... Original start winding open. When powered up controller reads ok. When selecting dry, I hear a click (relay on control board) but nothing happens... No motor hum... nothing... The included install sheet was barely readable but old and new motors appears to be the same... so wired the belt sensor switch the same way as original... Any Ideas? Is there a PDF of the tech sheet?

Important Information: The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More Details Close