|
On the new model dishwashers after heating element burnt out I had to perform a reset to get the heater to turn back on, so pick three buttons. Button 1, button 2 and button 3. Press button 1,2,3 again 1,2,3 again 1,2,3 it should start a diagnostic after it completes the diag (about 10 min) it clears the codes and should start working.
|
|
I have a Whirlpool Model GU 1500XTL. At the time I was advised that it could either one of three things, element, thermostat or ( I think) thermocouple. Since it was a semi-built in which involved some work getting it out, I replaced all three items and it's been working fine for four years. I have no idea which part was defective but the cost for all three parts was less than one service call. Good luck with yours.
|
|
I have same problem with a whirlpool wdt710paym2. It does not heat water or dry it. Just replaced the element as it was cracked but still no heat. Does this apply too?
|
|
Thanks for the very complete response to my questions. The service on this site is awesome. Collecam
|
|
|
| THIS FORUM IS DEAD!!!!!!! |
|
No water heating or heat drying in dishwasher. Water heating light does come on on control panel. Element, thermostat or is there are water temp sensor in this model? I couldn't find reference to one in the diagrams. Thanks if yiou can help or even if you can't.
|