Oven Repair (including Ranges and Cooktops)

smtowne@cox.net · #1 (**permalink**) 04-10-2008, 07:15 PM

The replacement board has different relays than the original. L1A and L1B which are tied together only have one relay that it will plug into. Broil relay is the closest one. This leave the Bake relay without a wire plugged into it. Can anyone explain how the new controller board should wire up to the older oven?

Thanks, Steve

Gene · #2 (**permalink**) 04-11-2008, 02:38 PM

Steve,

There is one more terminal for the L1 line on the board.

There is only one wire should be plugged into the "Bake" relay (the yellow wire from the "bake" terminal on the old board should go to the "NO" terminal on the relay) while the two wires (the L1 to the "COM" and the violet to the "NO") should go to the "Broil" relay.

All other wires from the old board should be connected to the same marked terminals on the new one.

The new control board usually comes with the complete installation instructions.

Gene.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GE oven controller replacement	Edyer	Oven Repair (including Ranges and Cooktops)	0	04-27-2009 04:20 PM
Compressor or Controller Board?	DanS2	Refrigerator & Freezer Repair	3	01-08-2009 06:42 AM
Controller board replacement Hotpoint fridge	seabird	Refrigerator & Freezer Repair	1	11-26-2008 02:39 PM
new controller board won't enter service mode	wagstdy	Dryer Repair	0	09-01-2008 11:26 AM
New Controller Board won't light	leadnovel	Oven Repair (including Ranges and Cooktops)	1	05-10-2008 05:53 PM

GE Oven Controller Board Replacement

Oven Repair (including Ranges and Cooktops)

The replacement board has different relays than the original. L1A and L1B which are tied together only have one relay