Customer Support 7 days a week

Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

New Topic Post Reply
Options
Go to last post Go to first unread
dennysim  
#1 Posted : Monday, January 4, 2010 3:54:53 PM(UTC)
Quote
dennysim

Rank: Member

Groups: Registered
Joined: 1/4/2010(UTC)
Posts: 1

I just installed a new clock display module but I still have no display the oven still works but there is no display read out
Sponsor
See inside of your appliance - diagrams and part photos for virtually every model.

powered by AppliancePartsPros.com
 
denman  
#2 Posted : Tuesday, January 5, 2010 2:40:47 AM(UTC)
Quote
denman

Rank: Advanced Member

Groups: Senior Expert
Joined: 2/29/2008(UTC)
Posts: 19,638

Thanks: 1 times
Was thanked: 11 time(s) in 11 post(s)
Here are your parts
Oven replacement parts for JENN-AIR JJW9530AAB Walloven - S/c Ele | AppliancePartsPros.com

Here is a manual
http://www.servicematters.com/m...ibrary/docs/16010312.pdf

It could be that the transformer which supplies power to the display is shot.
I believe this is on the relay board but am not 100% sure.
Looking at the wiring diagram in the manual it shows the transformer secondary has 2 windings. One at 4 volts (probably runs the electronics) and one at 21 volts (probably runs the display). I would check these voltages.
Also check the wire/connections between the relay and control boards.

If OK then you may have received a defective replacement.
THIS FORUM IS DEAD!!!!!!!
Quick Reply Show Quick Reply
Users browsing this topic
New Topic Post Reply
Forum Jump  
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.