Oven Repair (including Ranges and Cooktops)

Ajit · #1 (**permalink**) 11-14-2009, 09:31 AM

The oven keeps beeping with a F1 fault code on display. Temporarily stops when "STOP/CLEAR" is pressed. But starts again in a few minutes/seconds. I finally had to turn off the circuit breaker. When I restart, it could be several hours before it starts beeping again. Once it starts beeping, the only way to stop it is to switch off the oven circuit breaker.

denman · #2 (**permalink**) 11-15-2009, 03:20 AM

Here are your parts
Replacement parts for MAGIC CHEF 59G-5TXW | AppliancePartsPros.com

F1

1. Watchdog on board
2. Touch membrane defective

To determine which component is at fault, disconnect ribbon strip. If NO fault code, replace membrane, otherwise replace board

Above is the only info I could find on erro codes on a Magic Chef.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help with my Magic Chef wall oven	Joe Garza	Oven Repair (including Ranges and Cooktops)	1	01-14-2010 01:57 AM
Help with my Magic Chef wall oven	Joe Garza	Oven Repair (including Ranges and Cooktops)	0	01-12-2010 02:03 PM
magic chef wall oven	trikerdave	Oven Repair (including Ranges and Cooktops)	1	04-22-2009 01:14 PM
Magic Chef self-cleaning wall oven	Chuck Stemple	Oven Repair (including Ranges and Cooktops)	0	04-22-2009 12:52 PM
Magic chef dual elec. wall oven	jbduvall	Oven Repair (including Ranges and Cooktops)	1	04-21-2009 11:52 AM

Magic Chef Wall Oven - Constant Beep F1

Oven Repair (including Ranges and Cooktops)

The oven keeps beeping with a F1 fault code on display. Temporarily stops when &quot;STOP/CLEAR&quot; is pressed. But starts again

The oven keeps beeping with a F1 fault code on display. Temporarily stops when "STOP/CLEAR" is pressed. But starts again