Rank: Member
Groups: Registered
Joined: 10/7/2009(UTC) Posts: 1
|
I just replaced a bad control board in my oven. Throughout my research when troubleshooting, I recall seeing a thread requiring new control boards to be calibrated to the size of the oven. I cannot seem to relocate that thread.
The replacement control board part number is AP3851248.
Can someone tell me if I have to configure this new board and if so, what are the steps.
Thanks in advance. By the way, oven is working with the new board.
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert, Administrators Joined: 7/19/2007(UTC) Posts: 27,455
Was thanked: 4 time(s) in 4 post(s)
|
I believe the new board comes programmed for 30" cavity size and you do not have to do anything. You can find the programming instructions in the Tech sheet. Gene.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close