control board replacement
Model Number: JJW9630CAS Brand:
More than 10 years
I bought a control board from your site for Jenn Air wall oven JJW9630CAS (serial 11329691AT). I replaced the old board (had a fused contacts on broil power relay) with new one.
The bottom oven that runs from auxiliary board linked to the primary board runs fine.
I don't get any power to top oven broiling heating element or baking heating element. The only noticeable difference between boards is that one of L2 (line 2) feeds has changed to a location E18 (new board) vs. location E7 (old board). If the bottom printed side of the board didn't change that would cut off feeding L2 to a leg of broil and bake power relay.
Is it possible? You say on the web sites which parts number the board is replacing... and this is there. Is it a solution to re-solder the prong from E18 to E7 ?. Do you have any variations of this board with the hookup similar to my old board ? Any further advice?
Checked the resistance of heating elements ~20 ohms, thermal probe ~ 1100 ohm, so they are OK.