Oven Repair (including Ranges and Cooktops)

carleisenberg · #1 (**permalink**) 02-17-2013, 06:01 AM

The probe indicator is on, and asking me to remove the probe.
By going to roast or bake i can start the oven but not clean or do anythihg else. I am gong to guess it is the control panel.

Carl

denman · #2 (**permalink**) 02-19-2013, 04:03 AM

Are you sure that the last digit is a Z and not a 7?
No info comes up for a DWHZ.

Below is info on a KEBS277DWH7

Here are your parts
Parts for Whirlpool KEBS277DWH7 Wall Oven - AppliancePartsPros.com

See the attachment for the tech sheet

I would disconnect the meat probe at the control board before replacing the control board, just to be sure that some crud has not contaminated the probe jack and the unit is reading this as the probe being connected.

You could also check the probe resistance when it is not installed.
Then unplug/remove power from the unit.
Install the probe then check it's resistance at the control board.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
control panel problem	jerry10	Oven Repair (including Ranges and Cooktops)	1	02-18-2011 04:02 AM
take front panel off to see problem	carpendi	Washer Repair	5	12-29-2010 12:28 PM
Control Panel Problem	carwade	Dishwasher Repair	1	10-04-2009 10:59 AM
control panel problem	LOOTY	Refrigerator & Freezer Repair	0	08-26-2009 02:58 PM
Control panel problem	1toolmom	Oven Repair (including Ranges and Cooktops)	0	08-07-2008 11:06 AM

Panel Problem

Oven Repair (including Ranges and Cooktops)

The probe indicator is on, and asking me to remove the probe. By going to roast or bake i can