Rank: Member
Groups: Registered
Joined: 1/18/2013(UTC)
Posts: 1
|
Both of my ovens are very inconsistant in heating, sometimes when you set temperature, it's accurate, other times it heats 100 degrees below setting and sometimes 100 degrees higher than setting. Do I need new heating elements or could the heat sensor be bad? I can't imagine both ovens going out in the same way at the same time so I'm thinking it's not the heat elements. Thanks
|
|
|
|
|
|
Rank: Advanced Member
Groups: Senior Expert
Joined: 2/29/2008(UTC)
Posts: 19,638
Thanks: 1 times
Was thanked: 11 time(s) in 11 post(s)
|
Here are your parts Parts for MER6775BA - AppliancePartsPros.comYou seem to be missing a letter at the end of your model number so you will also have to use "Matching Model Numbers" on the left side. Do I need new heating elements or could the heat sensor be bad? I can't imagine both ovens going out in the same way at the same time so I'm thinking it's not the heat elements. The same would apply to the oven sensors. You could check them see the below link, look at 7, 8, 20 and 21. http://www.applianceaid.com/ele...-range-repair-topics.phpMy best guess would be that the control board is bad. |
THIS FORUM IS DEAD!!!!!!! |
|
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
