|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Range/Blower |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
12-13-2012, 10:09 AM
|
|||
|
|||
Range/Blower
Model Number: KGRA806PWH00 Brand: Kitchen Aid Age: 5 - 10 years
KGRA806PWH00-Range powered off 2x after sel-clean cycle.
Replaced/reset thermal fuse. During cool down made loud vibrating sound from old blower motor. ORIGINAL CAUSE IS BLOWER-OLD P/N-8300223 (1500RPM) with new blower P/N-9759320 (2250RPM). Problem with old motor was it slowed down and could not cool properly due to C-Frame MOTOR armature (rotor) delaminating, getting caught in magnetic field slowing down, causing noise and vibration. Relpacement was easy-All work done from back of range. 1.Pull range away from wall.2.Shut off gas and disconnect power.3.remove braces and back panel.4.blower cover is held in wit 4 screws. Rather than offset screwdriver-remove side panels to access 4 screws.5.Remove old blower.6.Replace new blower and reassemble all. Works better than new. Great air flow, no noise or vibration. Good Luck and have fun! Len B. Ads By Google Related Models 
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Blower gone bad? | bobbygerber | Dryer Repair | 0 | 02-07-2012 11:00 AM |
| Blower Fan | BOB40 | Dryer Repair | 1 | 11-23-2011 10:00 AM |
| blower | soubs | Dryer Repair | 0 | 08-03-2010 07:18 PM |
| Replacing trim on range blower | Toddap | Oven Repair (including Ranges and Cooktops) | 1 | 05-28-2010 02:51 PM |
| Blower does not come on | kbappliance | Heating, Ventilation, and Air Conditioning (HVAC) | 0 | 07-08-2009 10:56 AM |
Linear Mode
